QUIKRETE® Acrylic Concrete Cure & Seal forms a tough, water-resistant finish that is virtually unaffected by exposure to water, common acids, alkalies, petroleum, solvents, oils, greases, and salts. QUIKRETE® Acrylic Concrete Cure & Seal quickly penetrates the surface of concrete, flagstone, or unglazed tile to harden, protect and preserve the material. Use it to seal walks, driveways, garage floors, concrete porch decks, steps, patios, exposed aggregate finishes, and any other concrete surface exposed to weather and harsh environments.

• QUIKRETE® Acrylic Concrete Cure & Seal
  
• QUIKRETE® Concrete & Asphalt Cleaner
  
• Scrub brush
  
• Broom
  
• Paintbrush
  
• Roller Mop or squeegee
  
• Clean container

1. Remove all wax, oil, grease, dirt and dust from the surface to be sealed. Use QUIKRETE® Concrete & Asphalt Cleaner, as needed.

2. Allow the surface to dry completely before applying sealer.

Application

1. Pour the QUIKRETE® Acrylic Concrete Cure & Seal slowly into a clean container. Stir gently but thoroughly to mix. Rigorous stirring can form air bubbles in the sealer, which could affect the final finish.

2. Apply a small amount of sealer to an inconspicuous area to ensure aesthetic compatibility.

3. Apply to the dry surface full strength, using a brush, roller, mop or squeegee.

4. In most cases, one coat provides sufficient protection. Very porous surfaces may require two coats. Allow to dry 2 hours between coats.

For Best Results

• Do not apply at temperatures below 40° F.
• Do not apply if rain is likely. Never thin QUIKRETE® Acrylic Concrete Cure & Seal with water solvents.